The latest Controller Editor version is included in the latest KOMPLETE KONTROL software update. Controller Editor 1.8.0 or higher has to be installed on your computer.You can find further instructions on how to update a firmware in this article. You can download the 'Device Updater for KOMPLETE KONTROL S-Series 1.1.2' from this page. Firmware 56 or higher has to be installed on the KOMPLETE KONTROL MK1 keyboard.Additionally, the software and firmware must meet the following requirements: In order to use the KOMPLETE KONTROL S-Series as stand-alone MIDI controller, you have to disconnect the USB connection from your computer and use the NI Power Supply (18 W). Please note that the default MIDI mapping is not editable. "Using the Keyboard as Stand-Alone MIDI Controller". You can find the MIDI Assignments of the Keybed and Knobs of the MK2 in the KOMPLETE KONTROL MK2 manual in chapter 9.4. The knobs and the buttons on the keyboard send out the default MIDI CC messages. The power supply is available in our NI Webshop. In order to use the KOMPLETE KONTROL MK2 keyboard as stand-alone MIDI controller, you have to disconnect the USB connection from your computer and use a NI Power Supply (18 W). Depending on your keyboard model, you can find further information and requirements below: MK1 You can use the KOMPLETE KONTROL S-Series keyboard as a stand-alone MIDI controller without USB-connection and connect your external MIDI equipment to the 5-pin MIDI ports on the KOMPLETE KONTROL S-SERIES’ rear panel.
0 kommentar(er)
